Bell System bellissimo Especificaciones descargar pdf (Pagina 7)

bellissimo 1 Way Video Entry System

Installation and Operating Manual Page 4 of 25

Call Privacy

Once a call has been answered by one videophone no other videophones may join

in, view or listen to the call. If another videophones handset is picked up the

videophone will not activate; pressing the view button on another videophone will be

ignored.

User Activation (CCTV Mode)

While the system is idle, pressing the view button will activate the system and display

the picture at the entrance panel. Once activated, lifting the handset will enable

speech at the entrance and the lock button may now be used to release the door or

the user can hang-up. The picture will switch off after the preset talk-time.

Second camera

The Door Controller has the capability of driving a second ‘third party’ ‘CCTV’

camera, which is located nearby, and offering a different viewpoint. Pressing the

‘View/Camera’ button will alternate the view between the primary and secondary

camera (if enabled).

Extension Videophones

Additional videophones may be added to the basic system. The number of

extensions is limited only by power supply considerations. All videophones will ring

when called however typically only the Master unit will display a picture while ringing.

Once the master or extension videophone is ‘picked-up’ the picture will display on

that unit alone.

It should be noted that when the Master unit is left off-hook, extension videophones

will not ring; the red light will flash on the Master as a warning of this condition.

Lock Type and Operation

The door controller supports both fail-secure and fail-safe locks including magnetic

locks of up to 1A rating. The lock output is provided by relay contacts, which in the

event of power failure are open.

On pressing the lock button the lock timer will start and the door will unlock. The

picture (and speech if active) will persist for the first 3 seconds of lock operation. For

Lock Time settings see page 12.

Exit Button and Fire Switch

An input is provided for an exit button, which can be installed on the inside of the

door and allow residents to exit freely. Momentary operation of this button will

operate the lock release for the programmed lock time. A Fire switch or other

override device may use the same input to hold the door open indefinitely.

Trades Facility

Use of a time clock in conjunction with a trades button will allow free access during

the programmed time.

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Sin comentarios

Bell System bellissimo Especificaciones Pagina 7