Bell System bell free Manual de usuario descargar pdf (Pagina 13)

Bellﬁ res

English

Instructions for use and installation instructions

• The appliance will automatically revert to stand-by if:

the hand-held transmitter is outside the range of the receiver for more

than 6 hours.

the batteries in the hand-held transmitter are almost depleted.

the batteries in the receiver are fully depleted.

• When one of the buttons on the hand-held transmitter is pressed (except

the SET button), the transmission symbol

appears on the screen.

The receiver conﬁ rms the transmission with an audio signal.

Operating day temperature thermostat

(Appliance is in the stand-by position and the pilot light is burning.)

Automatic temperature regulation of the pre-set day temperature.

The room temperature is measured and compared with the pre-set day

temperature. The ﬂ ame height is automatically regulated so as to reach the

pre-set day temperature.

Also see: Setting the desired temperature.

Operating the night temperature thermostat

(Appliance is in the stand-by position and the pilot light is burning.)

Automatic temperature regulation of the pre-set night temperature.

The room temperature is measured and compared with the pre-set night

temperature. The ﬂ ame height is automatically regulated so as to reach the

pre-set night temperature.

Also see: Setting the desired temperature.

Timer operation

(Appliance is in the stand-by position and the pilot light is burning.)

Appliance functions automatically according to the two pre-set heating periods;

P1 and P2. These heating periods repeat automatically every 24 hours.

Also see: Programming the timer: P1 and P2.

The appliance works thermostatically at the pre-set starting times P1 and

P2 and the room temperature is automatically regulated to the pre-set day

temperature .

The appliance works thermostatically at the pre-set stopping times P1

and

and the room temperature is automatically regulated to the pre-set night

temperature

In order to allow the appliance to regulate the temperature at night, the night

temperature

must be set to at least 5°C.

If the setting is lowered to , the appliance will switch to stand-by

at night. The appliance will automatically operate at the following day cycle

N.B.: The pre-set temperature is shown on the screen every 30 seconds.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Comentarios a estos manuales

Sin comentarios

Bell System bell free Manual de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta Bell System bell free