Bell System bell free Manual de usuario descargar pdf (Pagina 17)

Bellﬁ res

English

Instructions for use and installation instructions

2 Receiver:

* Carefully pull the receiver assembly out of the compartment.

* Open the cover.

* Remove the batteries from the battery compartment.

* Place four new 1.5V batteries (LR6 or AA type) as indicated in the battery

compartment. The negative end (-) of the battery must always be at the contact

spring end of the compartment.

* Close the cover and place the receiver back in its holder.

• If the batteries are inserted incorrectly, the electronics or drive may be irreparably

damaged.

• Only replace the batteries when the appliance has been completely switched off.

Figure 4: Gas regulating block; Operating Knob in MAN-position

2.3.4 Operation (Hand control)

In an emergency it is possible to operate the appliance manually. To do so, the ignition

(piezo) cable must ﬁ rst be removed and transferred carefully to the piezo connector on

the gas control block.

Motor-Knob

(in maximum position)

Microswitch

Operating Knob

(in Position for

Manual Ignition)

Metallic Core for Manual

Ignition (recessed switch)

Connection Piezo Igniter

(only for MANual control)

ON/OFF Switch

8 Wire

Receiver Jack

Piezo button

(only for MANual control)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Sin comentarios

Bell System bell free Manual de usuario Pagina 17