Bell System bell free Manual de usuario descargar pdf (Pagina 15)

Bellﬁ res

English

Instructions for use and installation instructions

Figure 3: Gas regulating block; Operating Knob in ON-position

Motor-Knob

(in maximum position)

Microswitch

Operating Knob

Connection Piezo Igniter

(only for MANual control)

ON/OFF Switch

8-wire

Receiver Jack

• Possible error messages:

* 3x short audio signal, audible when the motor-knob operates:

Receiver batteries need changing soon (having heard this signal, the

appliance can be ignited another ten times approximately).

* 5 second unbroken tone:

Error. For example, one of the cables may not be properly connected,

the “O I” switch is not in the “I” position.

* 5 short beeps:

Ignition of the pilot light and main burner failed. Possible cause: air in

the pilot light pipe.

Important: If the pilot ﬂ ame goes out, then wait for

at least 5 minutes before repeating the

above procedure.

Setting the ﬂ ame height / extinguishing the ﬁ re

• After ignition, the burner automatically sets the ﬂ ames to the maximum height

• Press button

(small ﬂ ame) to lower the ﬂ ames and to turn off the main burner

(Extinguishing the ﬁ re: small ﬂ ame button: pilot light remains burning!)

(Pressing brieﬂ y the (small ﬂ ame) button gradually lowers the ﬂ ames to the low

position.)

• Press button (large ﬂ ame) to increase the ﬂ ame level and to turn on the burner.

(Pressing brieﬂ y the (large ﬂ ame) button gradually increases the ﬂ ames to the

high position.)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Sin comentarios

Bell System bell free Manual de usuario Pagina 15