14
Bellfi res
English
Instructions for use and installation instructions
Setting the desired temperature
• Select the desired mode of operation or
by pressing the SET button
briefl y.
• Hold the SET button until the display fl ashes.
• Set the temperature with (large fl ame) or (small fl ame).
• Wait or press the OFF button briefl y to go to mode.
• If the temperature control in should be off (lower battery consumption),
decrease the night temperature until appears on the display.
Important: Place the hand-held transmitter in a place that is not
infl uenced by direct sunlight, draught, heat from
the appliance and other heat sources.
Programming the timer: P1 and P2
• Select the desired mode of operation
by pressing the SET button briefl y.
• Press the SET button until P1 (heating period 1) and the time fl ashes.
• Set the time for the beginning of the fi rst heating period by pressing (large fl ame)
for houre and (small fl ame) for minute’setting.
• Press the SET button briefl y; P1
appears on the display. Set the time for the end
of the fi rst heating period.
• Press SET again to set the second heating period P2
(heat ON) and P2
(heat
OFF).
• Wait a moment or press OFF to switch back to
mode.
2.3.3 Operation (Remote Control)
Igniting the fi re
• Open the gas supply valve in the gas pipe to the fi re.
• Press the “O I” switch on the gas control block to the “I” position.
• Turn the operating knob on the gas control block to the ON position.
• Switch the hand-held transmitter to the
position.
• On the hand-held transmitter, press the «- OFF and (large fl ame) buttons
simultaneously. A short tone will signal the start. Short beeps will then follow until the
pilot light and main burner are ignited. Once the main burner has been ignited, the
fl ame height will automatically rise to the maximum position.
Important: • If the pilot fl ame goes out for any reason, wait for 5 minutes
before attempting to re-light it.
• If the pilot light does not ignite after 3 ignition attempts;
close the gas tap and warn the fi tter.
• Once the pilot light is burning, the main burner must ignite
within 10 seconds automatically.
If this does not happen, immediately close the gas tap and
warn the fi tter.
• If the main burner ignites with a pop; immediately close the
gas tap and warn the fi tter.
(48 paginas)
(28 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales